Trico Rear Wiper Blade For Toyota GSU Kluger 2008-On

Item:
Rear wiper blade
Trico Exact Fit Rear
**Please Note - Only rear wiper blade, not whole arm**
Part# 12-A
Length: 300mm / 12 inches

Vehicle Application:
2008 - on Toyota Kluger GSU** Series models

These blades are designed to replace factory standard blades
**Compare and check sizing with your vehicle as yours may have been changed previously and won't match**

Trico® Exact Fit® REAR

TRICO Exact Fit Rear Window Wiper makes it easy to restore your vehicle to original factory quality. Made from the finest quality natural rubber and high-strength steel, they offer long-lasting performance. Exact Fit arm connection for fast easy installation.

Specifications

• Robust high-strength polymer shell
• Provides critical rear windowsheild visibility
• Exact Fit design for unique rear wiper arms
• 100% natural rubber fully bonded non-replacement wiper

Trico® Wipe Performance Diagnosis

Inside the Vehicle

Squirt the washers and do a visual wipe test.
Look and listen for the 6 symptoms of poor performance;

• Streaking - fit a new blade
• Smearing - clean the screen & blade or fit a new blade
• Squeaking - fit a new blade
• Shuddering - fit a new blade
• Fishtailing - fit a new blade
• Unwiped - clean the screen & blade or fit a new blade

Outside the Vehicle

Visually inspect the blade assembly for damage and 'layover'. Layover is usually caused by excessive wear in the blade assembly. Change blade if required.

Lift the blade assembly up off the windscreen. Grab the wiper insert or rubber element in the centre directly opposite the blade to arm adaptor. Check for lateral (sideways) movement. If you can move the insert 5mm or more in total the blade assembly should be replaced.

Lateral wear of the blade-to-arm adaptor can produce excessive movement. Check for excessive movement or 'wobble' of the blade assembly away from the wiper arm. If there is free-play here it will accentuate the lay-over effect, significantly reducing the life of the wipers. If wear is found in the adaptor, the blade assembly should be replaced.